中国女篮亚洲杯赛程-土超积分榜-cba最新赛程表季后赛-今日竞彩篮球结果查询|www.gyxrj.com

The reason why the heating tube of the natural gas mold temperature machine will burn out is actually because of a quality problem of the heating tube itself. The next thing is actually because the process problem directly leads to the natural gas mold temperature machine. There will be air on the surface of the heating tube. At this time, it will directly cause the phenomenon of dry burning of the heating tube.

No matter how good the natural gas mold temperature machine is, when it cannot solve the problem of dry burning, it is actually more likely to cause the problem of dry burning of the heating tube. As far as this issue is concerned, we actually have to pay attention to the main reason, which is actually caused by improper operation.

When using the gas-fired mold temperature machine for the first time, we actually have to pay attention to the fact that it should be heated directly after it is photographed. It is because of this that it actually causes the heat pipe of the mold temperature machine There is a phenomenon of dry burning. As soon as the heater starts to work, when the motor heats up, when the motor is just started, for water, it does not actually enter the machine. The heater actually does not have the medium of water. It will cause the phenomenon of direct dry burning.

The natural gas mold temperature machine working for a long time actually shortens the service life of the heater itself to a certain extent. It is because of this that it actually makes the heater often prone to damage.

In order to avoid the phenomenon of dry burning of the natural gas mold temperature machine, we actually need to pay attention to the fact that two buttons should be set directly on the circuit board, which are the motor start button and the heater start button. In fact, to a large extent, it is required that the operator of the natural gas mold temperature machine must first start the motor button to prevent the heater from burning.