中国女篮亚洲杯赛程-土超积分榜-cba最新赛程表季后赛-今日竞彩篮球结果查询|www.gyxrj.com

Regarding the overheating of the natural gas mold temperature machine due to its thermostat problem, first of all, we will actually notice that for the natural gas mold temperature machine, it can actually be directly through the thermostat. Output signal, the next thing, we actually need to pay attention to the work of the electric heating tube itself.

When a series of problems occur in the thermostat of the natural gas mold temperature machine, when the temperature reaches the set value, the thermostat actually does not emit a series of signals. In fact, we should pay attention to the fact that the electric heating tube should be stopped for heating. As far as its temperature is concerned, it is actually rising all the time. At this time, in fact, the phenomenon of overtemperature will occur.

If the natural gas mold temperature controller has overheated, it is actually because the solenoid valve (or other control valve) that controls the cooling water has burned out. In this regard, it will actually be in many In all cases, it is in a closed state. When we need to cool, we find that it is not allowed to enter the cooling water. At this time, it actually causes the temperature to be too high.

The overheating phenomenon of the natural gas mold temperature machine is actually because the settings on the electrical part are not in place. In this regard, when there is a problem such as heating, it can actually be replaced by a heating tube directly. It’s okay.

The overheating phenomenon of the natural gas mold temperature machine actually refers to the temperature-controlled equipment. To a certain extent, it actually belongs to the heat release process. In this regard, we actually notice that The power of the natural gas mold temperature machine cooler is too small, but in terms of its cooling capacity, it is actually less than the heat absorption of the heat transfer medium in our temperature-controlled equipment.