中国女篮亚洲杯赛程-土超积分榜-cba最新赛程表季后赛-今日竞彩篮球结果查询|www.gyxrj.com

Speaking of the phenomenon that the heating tube of the mold temperature machine will burn out, first of all, we will actually notice the quality problem of the heating tube, and then, we will actually notice that it is actually due to process problems. There will be air on the surface of the heating tube that causes the heating tube to dry and burn. It is precisely because of this that we actually find that it has a series of malfunctions.

    The reason why the heating tube of the mold temperature machine is dry-burning, for the main reason, it is actually caused by its own improper operation. In this regard, it is actually because we are using it. In fact, it did not finish the air in the mold temperature machine, that is, it will directly heat and cause a series of dry burning phenomena in the heating pipe of the mold temperature machine.

    The reason why the mold temperature machine will be burned when it is heated is that it starts work immediately. In terms of heating, it is because the motor has just started and the water has not yet entered the machine. When there is no water in the heater, it will cause the phenomenon of direct dry burning. Work, in fact, will shorten the life of the heater, the heater will be damaged.

    Regarding this problem caused by the mold temperature machine, for the manufacturer, in fact, it will directly design a more important solution. As far as the circuit board is concerned, in fact, it will directly set up two buttons, namely the motor start button and the heater start button.

    In this respect, in fact, it will require the operator of the mold temperature machine to start the motor button first. After the water is completely replenished, operate the heater button. In this regard, in fact, it will be in To a certain extent, the phenomenon of dry burning of the heater of the mold temperature machine is prevented, but there are many aspects to be paid attention to when it is operated.